This genuine Elegoo Assembled Hotend Kit provides a direct, drop-in replacement for the high-volume extrusion systems on the Neptune 4 Plus and Neptune 4 Max. Arriving as a fully pre-assembled module, it eliminates the hassle of rebuilding the heater block or splicing thermistor wires, allowing you to quickly resume printing after severe clogs or damaged components.
Engineered specifically for high-speed, large-format printing, the hotend utilizes a powerful 60W ceramic heating element and an extended all-titanium throat pipe. This architecture delivers rapid heating, an elongated melt zone, and stable performance up to 300°C, ensuring smooth and consistent volumetric flow for both standard and high-temperature engineering filaments.
Key Features and Benefits
- Factory Assembled: Arrives completely pre-built for a fast, hassle-free, drop-in installation.
- 60W Ceramic Heating Element: Provides rapid heating and superior thermal recovery for high-speed printing.
- Extended High-Flow Design: Elongated melt zone supports the high volumetric flow rates of the Plus/Max models.
- All-Titanium Throat Pipe: Engineered for extreme durability up to 300°C while preventing heat creep.
- .
CRITICAL - Compatibility Warning
- Verify your interface before purchase. This kit is fully compatible with both Ribbon-Cable and Type-C versions of the Neptune 4 Plus and 4 Max.
- It is compatible with the Neptune 4 and 4 Pro ONLY if they have been updated to utilize the newer Type-C hotend interface.
- Calibration: Always perform a PID Tune and re-level your bed after installation.
Parts Included with Elegoo Assembled Hotend Kit for Neptune 4 Plus / 4 Max:
(Note: This is supplied as a single, pre-assembled module)
– 1 x Assembled High-Flow Hotend Module (Includes Heat Sink, Titanium Throat Pipe, Heating Block, and 0.4mm Extended Nozzle)
– 1 x 60W Ceramic Heating Element & Pre-Wired Thermistor
– 1 x Internal PTFE Tube
– 1 x Mounting Hardware Set
